Around Issues of Wall

A good wall would not only be a strong supporter of the house, but also has a good vision, so that the beauty of the house itself can support. To remain attractive wall display, often encountered many obstacles, especially for a room in the tropical countries.

Issues arising from moldy walls, mossy, hollow, peeling paint, water stains, paint bubbled up to the walls crack. What is clear, you can not remain silent on this issue dragging. Besides disturbing the beauty and home health care, you and your family can be more uncomfortable in the house. And you do not directly call a carpenter to repair the wall. If free time, you can use to repair. Here are some issues that often arise walls:

- Walls covered with mold and moss
Fungi that cause stains on the wall clearly disturbing visions and environment and health of the house. A-one you and the health of your family suffers, too. This situation would be worse if the insulation / insulation and ventilation in a room not so good. The origin of this fungus from water vapor is absorbed by the wall. That is why many found moldy walls in the bathroom, laundry room, garage, and so on. If a window in the room, wide open and often closed. If more money, buying and installing a wall fan (exhaust fan) to further improve air circulation.

If you already moldy, clean with a spatula is not treated. Then spray the wall with clean water. Once dry, mix 500 grams of chlorine / bleach solution with 2 liter of water. Apply evenly to the wall and let one hours for fungi and algae die. Rinse with clean water and dry. Then brush the liquid anti-mold and mildew with a brush. Leave for 2-6 hours. Rinse again with clean water. Let dry on one days. Then paint the wall with regular paint. Once dry paint with a special paint anti-mold and moss.

- Hollow walls
Perhaps you long to know the condition of these walls. But since ignorance of the dangers of it, so you do not care about the condition. The main cause of the hollow walls of the wrong mix of concrete in building a wall. To create the right composition of concrete prepared 1 / 3 of cement and 2 / 3 sand. If you’re desperate for the sand to measure more than that amount, the walls are hollow. Beat that the knock on the wall as a blank in the middle, which means that the hollow walls. To prevent the hollow walls, new walls to dry for two weeks, then paint. Because if not dry and immediately painted the concrete is always damp and rainwater will seep through the cracked walls.

- Paint peeling walls
Again, the rain caused problems for the wall with paint terkelupasnya. For this, check windows and doors, make sure there is no gap. If, cover with a mixture of water-resistant silicone. Come on quickly peeling wall paint with a spatula mengeroknya and use the handle. Then sandpaper the surface of the wall to the rest of the paint is missing. To really clean, wipe with a dry cloth with a damp cloth. Use a roller to paint the walls with the base colors. Only one layer and let dry 1-2 hours. While waiting for the paint dry, exterior paint mixed with water as much as 10 percent of the amount of paint. Stir well and then use a roller to paint. Once dried (approximately 2-3 hours), paint the back with half low.

- Water stains on walls
In addition to rainwater, air leakage of water from pipes or drains you a wall of water stains. It can be overcome with a layer of waterproof sealer sealer but it will not take long for the wall is too wet. To recover, you need a carpenter call to the inner control.

- Wall Crack
Cracks that occur in the wall can actually be described in different types of damage. But that is often seen in the housing for the small damage is cracked and damaged hair that is cracked structure.

· Rift her (the width not more than 1 mm and not penetrate into the other wall) caused by poor finishing as they work acian / broken walls, stucco is not watered down at once / not really dry, broken plaster and the mixed results use of paint that no elasticity. There is an easy way to prevent the washings in the wall, wait a few minutes and start painting. This is to prevent quick drying paint and uneven. Remember, look for a good quality paint and keep the paint mixed with water viscosity.

· Rift structure (width greater than 2 mm and transparent to the other side) is caused by foundation movement is less than perfect. As a result of land could not support the building. Therefore, a contractor you enough time to build the building and select materials of good quality foundation.

- Paint walls bulging
Usually results from painting on the wall surface is still wet. You can deal with curry paint and paint again. Avoid painting in the rain, low temperatures and humidity.

No Comments

No comments yet.

RSS feed for comments on this post. TrackBack URI

Leave a comment